Skip to main content

Host Device Questions

3 replies [Last post]
rickbauer
Offline
Joined: 2010-09-10
Points: 0

Please refer to OC-SP-HOST2.1-CFR-I10-091211 for the following questions.

EQ3491.12 states that IEEE-1394 port status needs to be displayed but I don’t see any further detail within the spec. Is there a specific place, and format for this information?

REQ3499.5/REQ3499.6 states that the text for FDC power should be colored based on the power values, but there is no such requirement for RDC. Is this intentional or should the colors be the same for RDC?

REQ4752.1 states that the OCAP APPS page should be displayed using the template defined in figure 11.2-11, but it doesn’t state what to do if the information does not fit on the page. It only takes a couple applications to fill up a page due to the current format taking 5 lines for each application entry. Using one line for each application entry does allow for more applications, but this is not the correct format per the current spec. Is there a certain way we should be handling this? Also, the left column has the text “Applications” and then below it, “Status”. Is “Applications” listed once and then “Status” listed for each entry?

Reply viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.
rickbauer
Offline
Joined: 2010-09-10
Points: 0

Need a reply. Please investigate questions.

sheila_keller
Offline
Joined: 2008-02-26
Points: 0

Dear rickbauer,

Unfortunately, this forum is not the best way to contact CableLabs regarding host questions.

Please go to this link: http://www.cablelabs.com/opencable/contact/ and send your question into us.

Thank you!
Sheila

rickbauer
Offline
Joined: 2010-09-10
Points: 0

Thanks, I'll use the link.